This is a follow-up to my prior post on Getting SAS® Software running on Arch Linux 64-bit. In my quest for a new Linux distro the next stop was CrunchBang Linux. I like the look of CrunchBang because it’s lightweight, based on Debian, and uses Openbox by default. Being Debian based, like Ubuntu, I get to re-use the knowledge I gained from using Ubuntu over the last few years (it’s hard not to automatically type apt-get whenever I want to install something!). CrunchBang is not a rolling release distro like Arch or Gentoo but it’s other attributes make it well worth a look. I’ve seen a disclaimer on the web site where they say it “… could possibly make your computer go CRUNCH! BANG!” but from everything else I’ve read it sounds pretty stable. Anyway, I like my (own) computers to go crunch bang every now and then – it’s a great opportunity to learn something new ;)
I installed the CrunchBang 11 “Waldorf” 64-bit testing image in a multi-boot configuration, alongside Arch and Ubuntu, to test it with our existing SAS deployments. These are the steps I needed to take to get the existing SAS software installation running on CrunchBang 64-bit. As with Arch, no changes were needed to the SAS deployments, it just required a few minor changes and additional libraries for the CrunchBang installation.
After CrunchBang had been installed and I’d mounted the SAS installation volume, I tried to run SAS 9.3 M2 first and got the following error: Continue reading “Getting SAS Software running on CrunchBang Linux 64-bit”