Recently, I’ve been looking to switch from Ubuntu to an alternative distro as the primary Linux platform for our Metacoda development/testing environments, where we also run SAS® software. I’ve run quite a few distros in my time including Slackware, RedHat (pre-Fedora), Fedora, Gentoo & Ubuntu. Ideally I’d like something lighter and perhaps a rolling release too: lighter, so more resources go to SAS; rolling release, because given the choice I prefer regular small upgrades to occasional big upgrades. One of the potential candidates is Arch Linux and so I’ve recently installed it, in a multi-boot configuration with the existing Ubuntu installation, to test it with our existing SAS installations. This is one of the things I love about running SAS on Linux. The SAS software gets installed and configured once and the underlying operating system can be completely upgraded or replaced without having to re-install SAS. It might just take the installation of a few libraries to get everything working again but that’s not much compared to the effort of re-installing and configuring our SAS 9.3 M2, SAS 9.3 M0, SAS 9.2 and SAS 9.1.3 SP4 dev/test environments.
These are the steps I needed to take to get the existing SAS software installation running on Arch Linux 64-bit. No changes were needed to the SAS deployments, it just required a few additional libraries to be added to the Arch installation. If you’re wondering why several SAS versions?, it’s because we need to test our Metacoda software with each of them. The SAS 9.3 and 9.2 installations are 64-bit and the older SAS 9.1.3 installation is 32-bit (so takes a bit more work).
SAS 9.3 (and 9.2)
After Arch had been installed and I’d mounted the SAS installation volume, I tried to run SAS 9.3 M2 first and got the following error: Continue reading “Getting SAS Software running on Arch Linux 64-bit”